Product Overview
10 Ohm 1/8W 1% Metal Film Axial Resistors - 200-Piece Bag, Long Leads, RoHS Compliant
Condition
Unused NOS. Bulk bag of 200 axial-lead resistors sourced from an electronics distributor that was consolidating inventory. Lot label confirms: 1/8W, 10 ohm, 1%, 50PPM, qty 200, RoHS Compliant, lot R6490227. Blue bodies with five-band color coding and long tinned leads, body length approximately 3mm. Verify suitability before use.
Same or next business day shipping from our Idaho warehouse. Honest pricing, no nonsense.
Online since 1999. We are here for our customers, with a no-hassle satisfaction guarantee.
Product Overview
Xicon 270-10-RC metal film through-hole axial resistors, 10 ohm resistance, 1/8W power rating, ±1% tolerance, 50 PPM/°C temperature coefficient. Sold as a bulk bag of 200 pieces. Metal film construction delivers lower noise and tighter tolerance stability than carbon film alternatives - useful anywhere precision and consistency matter across a build.
Key Features
- Resistance: 10 ohm
- Power rating: 1/8W (0.125W)
- Tolerance: ±1%
- Temperature coefficient: 50 PPM/°C
- Construction: Metal film, through-hole axial
- Body length: 3mm; long tinned leads, total lead span approximately 65mm
- RoHS compliant - confirmed on lot label
- Quantity: 200 pieces per bag
Applications
- Breadboarding a new circuit design and need a stack of 10 ohm current-limiting resistors on hand - drop these straight into the tie points and move on
- Soldering a custom PCB and specifying 1% metal film for consistent LED brightness or accurate voltage divider ratios across every board in the run
- Diagnosing a vintage audio amplifier, pulling a drifted resistor, and dropping in a fresh metal film unit to bring noise back down and restore the original response
- Building an RC filter or sensor interface circuit where resistance drift with temperature would shift the cutoff frequency or reading - 50 PPM/°C keeps things stable
- Stocking a parts drawer for ongoing repair work so the right value is always there when a board comes in
Frequently Asked Questions
Are these suitable for vintage tube radio or amplifier repair?
Yes, with one check: confirm the voltage rating of your circuit does not exceed the rating for a miniature 1/8W metal film body. In low-voltage stages these are a solid upgrade over old carbon composition resistors - lower noise, tighter tolerance, better stability. In high-voltage tube stages, verify the voltage rating is sufficient before installing.
What is the mounting style - can these be used on a breadboard?
Through-hole axial. Long tinned leads make breadboard insertion straightforward. They also solder cleanly into standard PCB through-hole pads.
Do all 200 pieces ship together?
Yes. This listing is for one bulk bag of 200 pieces, as packed and labeled by the original distributor.
Are these RoHS compliant?
Yes. RoHS compliance is confirmed on the original lot label.
Two hundred 10 ohm resistors in one bag - enough to stock the drawer, finish the board, and still have spares when the next project shows up asking for the same value.
